Arroyo Instruments LaserSource 4200 Series Manuel d'utilisateur télécharger pdf (Page 6)

Page 6 · 4200-DR Series LaserSource User’s Manual

Quick Start

The 4200-DR was designed with ease of use in mind, and you will likely have

little need for this manual for almost all of the features the unit offers. This

section will show how you can quickly get the unit up and running in almost no

time.

After unpacking the unit, ensure that the voltage selection on the Input Power

Connector (IPC) on the back of the unit is set to the correct voltage. This is

critical, as incorrect voltages can damage the unit. The 4200-DR is typically

shipped in the 120V configuration from the factory, but always verify the voltage

selection. Change the voltage as needed. For more information, refer to the IPC

section below.

Once the voltage selection has been completed, plug the AC cord into the unit

and into the wall outlet. Turn on the power switch located on the back panel,

and the unit will power up, displaying the model information, serial number, and

firmware version number.

Press the Menu button to enter the menu, and using the knob, turn to the right

until the Io Lim setting is displayed. Press the knob to edit the setting, and

adjust the limit as appropriate to your laser diode. Press the knob again to save

the value. Make the same adjustments to the voltage limit (Vf Lim), as

appropriate for your application. Once you have made all your adjustments,

press the Menu button to exit the menu.

Next, connect the cables between your LaserMount or other fixture and the

OUTPUT connector of the 4200-DR. We recommend using our cables as they

have been designed to work well with the 4200-DR. If using your own cables,

ensure they have been properly wired according to the pin-out of the 4200-DR

and your fixture.

Finally, change the set points to an appropriate current and press the Output

button to turn the output on. When turning on the laser for the first time, it is a

good idea to start with a set point of zero and ramp up to the desired set point.

In this way, if the laser is wired incorrectly, the safety circuits will trip earlier and

minimize any chance of damaging the laser. Once you have confirmed proper

operation, the set point can be left at the desired operating point, and simply use

the Output button to turn the laser on and off.

For more detailed operating and installation instructions, read on.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Pas de commentaire

Arroyo Instruments LaserSource 4200 Series Manuel d'utilisateur Page 6